the brake lever is pulled or the
brake pedal depressed.
Operate the brake several
times until the brake pads are
bedded.
Seat the cable for the wheel-
speed sensor in retaining
clips 1 and 2.
Insert the wheel-speed sensor
into the bore and install
screw 3.
Wheel-speed sensor to
fork leg
Joining compound: Micro-
encapsulated or medium-
strength thread-locking com-
pound
8 Nm
Removing rear wheel
Lift the motorcycle, preferably
with a BMW Motorrad rear-
wheel stand.
Install the rear-wheel stand
(
130).
Slip wooden chocks or similar
under the rear wheel to prevent
it from dropping out after the
quick-release axle has been
removed.
Press brake caliper 1 against
brake disc 2.
Brake pistons are pushed back.
Remove nut 1 with the washer.
Slacken locknuts 2 on left and
right.
Slacken adjusting screws 3 on
left and right.
Remove adjusting plate 4 and
push the axle in as far as it will
go.
8
145
z