TouchPad button board
Table 6-10
TouchPad button board part descriptions and part numbers
Description
TouchPad button board
Before removing the TouchPad button board, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the optical drive (see
3.
Remove the bottom cover (see
4.
Remove the battery (see
Remove the TouchPad button board:
1.
Disconnect the system board cable from the ZIF connector on the TouchPad button board (1).
2.
Disconnect the TouchPad cable from the ZIF connector on the TouchPad button board (2).
3.
Remove the two Phillips M2.0 × 3.0 screws (3) that secure the board to the computer.
4.
Remove the TouchPad button board from the computer (4).
Reverse this procedure to install the TouchPad button board.
(Preparation for disassembly on page
Optical drive on page
Bottom cover on page
Battery on page
41).
34).
38).
Component replacement procedures
Spare part number
not spared
33).
53