Table of Contents
Advertisement
This section explains how to connect and configure your NewTek Connect Spark™ Pro. It
also explains how to update the device, and where you can find additional NDI
extend your workflow. After completing this short section, you'll be all set to begin using
your new camera.
This document briefly describes how to prepare your new NewTek™ device for use. Please note that more
detailed information is provided in the next chapter.
Step 1 – Downloads
1. Visit http://new.tk/NCSPInfo using the web browser of a computer and download the following:
a. NewTek NDI
b. Spark Pro™ User Manual.
2. Install NDI Tools on your computer.
Step 3 – Connect Spark Pro
Audio In
FIGURE 1-1
3. Connect Spark Pro to your local network router or switch with an Ethernet cable.
a. If you connect a PoE (power over Ethernet) cable, the unit will power up.
Section 1
Tools pack
®
HDMI In
Reset
QUICKSTART
Network
software to
®
USB-C
Audio Out
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Connect Spark Pro and is the answer not in the manual?