Logging In; Audio/Video Settings; Video Format - NewTek Connect Spark Pro Operating Instructions Manual

Select the newly listed channel for the Spark Pro unit you wish to configure. In a few moments, its
video output will appear in the Studio Monitor window.
3. The Video Monitor Settings menu shows an option near the bottom that lets you open the Device
Webpage in your system web browser. Select this item, and continue as follows.
Note: See Section 2.5.1 for details of an alternative method to locate your Spark unit on the network should
you have difficulty with the method detailed above.
1. Enter the Username "admin" and the default Password - also "admin".
FIGURE 2-7
After logging in, Spark's options and controls are
shown in your web browser (Figure 2-8).
Hint: The preview shown on the web page is not a
full motion video monitor, but updates periodically
to allow you to confirm the results of changes you
make to various settings.

VIDEO FORMAT

2.4.4
The first tab shown on the Spark Pro web page is
labeled Audio/Video Settings.
Video Format controls (Figure 2-9) allow you to
enable the 4k Video option. Doing so effectively
announces to connected HDMI video sources that
Spark Pro can accept UHD video, potentially
resulting in higher bandwidth usage for NDI
output when required.

LOGGING IN

2.4.2

AUDIO/VIDEO SETTINGS

2.4.3
Page 10 of 33
FIGURE 2-8