Rad Power Bikes Front Rack Owner's Manual page 9

Step 4:
Install the front rack on the bike
- Remove all four (4) screws from the head tube as shown. Apply lubricant to threads of screws as needed if it is difficult
to remove the screws. The screws have Loctite on the threads and locking washers to ensure the front rack is secure
when installed, so be careful to remove the screws slowly and carefully to avoid stripping the heads of the screws.
- Cut zip ties as necessary to separate the wires. It is very important to split the wires as shown below. The only wires
on the brake side (left side) of the bike should be the front and rear brake cables.
W W W . R A D P O W E R B I K E S . C O M
9