Canon Super G3 FAX Board-T1 Installation Procedure page 7

1.2.2 Mounting the Full
State Sensor Unit
If a full state sensor unit already exits, you may skip
the following steps:
1) Remove the front left cover [1] and the delivery
cover [2].
- 2 screws [3]
[3]
[1]
[3]
F-1-20
2) Remove the upper delivery cover [1].
- 1 screw [2]
3) Remove the rear cover [3].
- 1 screw [4]
[2] [1]
F-1-21
[2]
[3] [4]
4) Mount the full state sensor unit [1] to the delivery
assembly [2].
[2]
[2]
5) Route the harness [1] of the full state sensor unit
through the harness guide [2].
6) Connect the harness of the full state sensor unit to
the connector [1], and arrange the harness as
shown.
[1]
7
[1]
[1]
F-1-22
[1] [2]
F-1-23
F-1-24