Section 1: Getting Started; Installing The Battery; Removing The Battery; Charging The Battery - Samsung SPH-L500 Basic Manual

Section 1: Getting Started

Installing the Battery

1. Remove the battery cover by pulling up on
the slot provided.
2. Insert the battery into the back of the
phone, making sure to align the gold
contacts.
3. Replace the battery cover by aligning the
cover and pressing it gently into place.
DRAFT - Internal Use Only

Removing the Battery

1. Turn the phone off. Removing the battery
when the device is on may cause loss of
stored numbers or messages.
2. Remove the battery cover by pulling up on
the slot provided.
3. Lift the battery out of the device using the
slot provided.
4. Replace the battery cover by aligning the
cover and pressing gently until it clicks into
place.

Charging the Battery

Keeping track of your battery's power level is
important. If the power level becomes too low,
the phone turns off automatically, and you can
lose any unsaved information.
With the Virgin Mobile-approved Li-Ion battery,
you can recharge the battery before it completely
runs down.
Note: The battery comes partially charged, but
you should fully charge the battery before
using your phone. After the first charge, you
can use the phone while charging.
Getting Started 3