Limits Of Use; Electromagnetic Compatibility (Emc) - Cocraft NLT04 Original Instructions Manual

Hazards in use
WARNING! Watch out for erroneous measurements if the instrument is defective
or if it has been dropped or has been misused or modified. Carry out periodic test
measurements. Particularly after the instrument has been subject to abnormal use,
and before, during and after important measurements.
CAUTION! Never attempt to repair the product yourself. In case of damage,
contact a local dealer.
WARNING! Changes or modifications not expressly approved could void
the user's authority to operate the equipment.

Limits of use

Refer to section Specifications in the Instruction manual. The device is designed for
use in areas permanently habitable by humans. Do not use the product in explosion
hazardous areas or in aggressive environments.

Electromagnetic Compatibility (EMC)

WARNING! The device conforms to the most stringent requirements of the relevant
standards and regulations. Yet, the possibility of causing interference in other devices
cannot be totally excluded. FCC statement (applicable in U.S.): This equipment
has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4