Advertisement
Combustible Material
Non-Combustible Material
600mm
550mm
150mm
Failure to adhere to these clearance will invalidate the warranty
Hearth Requirements
Place the stove on a solid non-combustible hearth extending 300mm at the front of the stove,
150mm either side of the stove and 50mm at the rear. The hearth must have a thickness of at least
12mm. The maximum hearth temperature attained during testing was 52.2°C (Refer to document J of
the UK Building Regulations). Ensure that the floor has sufficient load bearing capacity. Fit a load
bearing plate if necessary.
Flue Requirements
To ensure that your chimney meets the required
specifications it must: -
be at least 5 metres high - have no bends
sharper than 45 degrees
be swept clear of any obstructions by a
qualified chimney sweep
terminate at least 1 metre above any roof
ridge
have an internal cross-section of between
0.018m2 and 0.14m2
be free from sources of leakage
be connected only to the one appliance i.e.
not a shared flue system
be well insulated, or have a wall thickness of
at least 100mm
INSTALLATION INSTRUCTIONS
300mm
150mm
and could damage your appliance/property.
Carron Revolution 5kw
Installation Clearances
Minimum clearance to
combustibles
Above the appliance - 600mm
Each Side of the appliance – 550mm
Rear of the appliance – 600mm
Minimum clearance to
non-combustibles
Above the appliance - 300mm
Each Side of the appliance – 150mm
Rear of the appliance – 150mm (this
can be reduced to 50mm if the wall
thickness is greater than 200mm)
CO Alarms
In accordance with building regulations, a
Carbon Monoxide Alarm, conforming to BS EN
50292:2002 must be fitted in the same room
whenever a new or replacement wood/solid
fuel or biomass appliance is installed in a
dwelling.
The alarm must be installed in accordance with
the alarm manufacturers instructions and is
not to be considered as an alternative to the
appliance being installed correctly and
subsequent regular maintenance of the
appliance and associated flue system.
Advertisement
