Starting & Stopping Wheel Drive - Snapper LT180H421BV2 Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
2,3 STARTING & OPERATION (Continued)
2,3.2, STARTING WHEEL DRIVE
1. Shift speed control lever to neutral.
2, Start engine. Refer to Section "STARTING
ENGINE".
3. Release clutch/brake pedal.
4. Slowly shift speed control lever forward for
forward motion or to the rear for reverse motion. See
Figure 2.7.
SPEED CONTROL LEVER
FIGURE 2,7
2,3.3 STARTING MOWER BLADE
1. Start engine. Refer to Section "STARTING
ENGINE".
2, Pull blade switch OUT to engage blade. See
Figure 2.8.
PUSH BLADE SWITCH IN TO
THE "OFF" POSITION
PULL BLADE
SWITCH OUT TO
THE "ON"
POSITION
2,4 STOPPING ENGINE, BLADE, WHEEL DRIVE
2,4.1. STOPPING ENGINE
1. Stop engine by turning key to the "OFF" position.
See Figure 2.9.
KEY
FIGURE 2.9
2,4.2. STOPPING WHEEL DRIVE
1. Fully depress clutch/brake pedal to stop wheel
drive. See Figure 2.10.
CLUTCH/BRAKE
PEDAL
FULLY DEPRESS
CLUTCH/BRAKE PEDAL TO
STOP WHEEL MOTION
FIGURE 2.10
FIGURE 2,8
Ik WARNING
DO NOT operate blades in reverse. STOP BLADES. I
LOOK and SEE behind and down for children, pets I
and hazards before and while backing. I
8