Filling The Coffee Brew Basket; Filling The Tea Brew Basket; Automatic Drip Stop - Ninja Hot & Cold Brewed System CP307 Owner's Manual

PREPARING & USING
THE NINJA HOT & COLD BREWED SYSTEM™ – CONT.
FILLING THE COFFEE
BREW BASKET
For best results, use the coffee
measurement chart to determine how
much ground coffee to use for each brew
size. The amount of ground coffee for each
size will remain the same for any brew type
you select. For example, if you select Cup
and Classic Brew, you will use the same
amount of coffee grounds as if you select
Cup and Over Ice Brew. The only exception
is Cold Brew, which requires one extra
scoop of coffee, regardless of the size.
1 Open the brew basket by sliding it
out of the brewer (Fig. 10). Ensure
you have the COFFEE filter holder in
the machine, denoted by the orange
handle with the coffee bean icon.
2 Place the coffee permanent filter or a
#4 paper cone filter in the COFFEE filter
holder. If using a paper filter, first ensure
the permanent filter is removed from
the filter holder. Then fold the paper
filter along the seams, open it fully,
and firmly press it into the filter holder
making sure it is fully seated (Fig. 11).
3 Use the Ninja Smart Scoop™
and follow the measurements in
the chart to fill the brew basket
(Fig. 12). These measurements vare
based on level scoops—adjust to your
preferred taste. We suggest using a
medium-sized grind if grinding whole
beans.
4 Slide the brew basket back into the
brewer until it clicks into place.

FILLING THE TEA BREW BASKET

For best results, use the tea measurement
chart to determine how many tea bags or
how much loose leaf tea to use for each
brew size. The amount of tea for each size
will remain the same for any brew type
you select.
12 1-877-646-5288
1 Open the brew basket by sliding it
out of the brewer (Fig. 10). Ensure
you have the TEA filter holder in the
machine, denoted by the green handle
with the tea leaf icon.
2 Place the tea permanent filter in the
TEA filter holder (Fig. 11). When
using tea bags, you may remove the
tea permanent filter if more space is
needed in the brew basket.
3 Use the Ninja Smart Scoop™ and follow
the recommended measurements in the
chart to fill the brew basket, adjusting
to your preferred taste (Fig. 12).
4 Slide the brew basket back into the
brewer until it clicks into place.
Fig. 10
or or
COFFEE TEA
Fig. 11
Fig. 12

AUTOMATIC DRIP STOP

The system is equipped with an automatic
drip stop. When the Drip Stop button
illuminated, the drip stop is closed and no
coffee or tea will flow out of the
brew basket.
When brewing a half or full carafe, press
the Drip Stop button to pause the brew
cycle and pour a cup. Promptly replace the
carafe and press the Drip Stop button
again to complete the brew (Fig. 13a).
NOTE: If you forget to press the Drip
Stop button to resume the brew,
the unit will pause the brew, and after
30 seconds it will give you a friendly
audible reminder. After 5 minutes, the
brew will be canceled.
DRIP STOP TIME SETTTING
After a brew is complete, the drip stop will
automatically close. Some types of coffee,
such as finely ground or decaf, can take
a little longer to fully drain from the brew
basket. To extend the amount of time the
drip stop remains open after a brew,
follow these instructions:
1 Press and hold the Drip Stop button
(Fig. 13a) until the clock display flashes
either dFLt (default) or the previously
specified time.
2 Press either the hour (H) or minute (M)
button until the desired extension time is
shown: dFLt (default), :15 (+15 seconds),
:30 (+30 seconds), :45 (+45 seconds), :60
(+60 seconds), or OFF (Fig. 13b).
NOTE: When OFF is selected, the drip
stop will remain open after a brew is
complete. You can close the Drip Stop
at any time by pressing the Drip Stop
button again. dFLt (default) is the
machine's default time setting.
3 Press the Drip Stop button
the new time. Or wait 5 seconds, and the
unit will beep, signifying that the new
extension time has been set.
is
Fig. 13a
Fig. 13b
ninjakitchen.com
to set
13