Snapper LT180H33 IBV Safety Instructions & Operator's Manual page 29

Section 4 - ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blade running. STOP
blade. STOP engine. Set brake. Remove key. Remove
spark plug wire from spark plug and secure wire
away from spark plug. Engine and components can
be extremely hot. Avoid burns by allowing engine and
components sufficient time to cool.
4.4.7. TRACTION DRIVE BELT REPLACEMENT
(Continued from previous page)
4. Remove mounting nuts that secure the traction
drive belt idler tension pulley and stationary idler
pulleys. See Figure 4.33.
STATIONARY
IDLER
PULLEYS
ENGINE
PULLEY
VIEW FROM UNDERNEATH TRACTOR
FIGURE 4.33
5. Remove traction drive belt from engine pulley top
groove. See Figure 4.34.
REMOVE BELT
FROM PULLEY
FIGURE 4.34
6. Remove belt from center belt guide.
7. Pull belt until
transmission pulley.
TRANSMISSION
PULLEY
TENSION
REMOVE
IDLER
ALL
PULLEY
PULLEYS
it can be removed
Traction drive belt replacement
1. Place new traction drive belt over transmission
pulley and span to engine pulley.
2. Place belt into top groove of engine pulley.
3. Route belt through stationary and tension idlers.
See Figure 4.36.
DRIVE BELT
NOTE: When installing a new belt, make certain the
stationary idler is mounted in the hole closest to the L.H.
side of the tractor. See Figure 4.35.
4. Make certain belt is within belt guides of idlers.
5. Attach tension idler spring to tractor frame. See
Figure 4.36.
6. Reinstall mower deck in reverse order of removal.
RIGHT REAR
TRACTOR FRAME
from
29
TRANSMISSION
PULLEY
TENSION
IDLER
STATIONARY
IDLER
STATIONARY
IDLER BRACKET
BELT GUIDE
STATIONARY IDLER
FIGURE 4.35
CONNECT SPRING
TO FRAME
FIGURE 4.36