Online Insertion And Removal - Cisco AS5800 Manual

Shield #4
RJ­45­to­Twinax Cable Pinouts
Figure 12 RJ­45­to­RJ­45 Interface Cable
Table 13
RJ­45
Pin Signal Description Direction
Shield Ground Shell/Braid
J1­1 RX Tip Twisted Pair
#1
J1­2 RX Twisted Pair
Ring #1
J1­3 RX Twisted Pair
Shield #3
J1­4 TX Tip Twisted Pair
#2
J1­5 TX Ring Twisted Pair
#2
J1­6 TX Twisted Pair
Shield #4
RJ­45­to­RJ­45 TE Cable Pinouts (Straight­through)
Table 14
RJ­45
Pin Signal Description Direction Signal
Shield Ground Shell/Braid
J1­1 RX Tip Twisted <—
Pair #1
J1­2 RX Twisted <—
Ring Pair #1
J1­3 RX Twisted
Shield Pair #3
J1­4 TX Tip Twisted —>
Pair #2
J1­5 TX Twisted —>
Ring Pair #2
J1­6 TX Twisted
Shield Pair #4
RJ­45­to­RJ­45 NT Cable Pinouts (Crossover)
Warning
The ports labeled "Network Clock," "10BaseT," "Dial Shelf
Interconnect," "Console," and "Alarms" are safety extra­low voltage
(SELV) circuits. SELV circuits should only be connected to other SELV
circuits. Because the E1/T1 circuits are treated like telephone­network
voltage, avoid connecting the SELV circuit to the telephone network
voltage (TNV) circuits.
Online Insertion and Removal
The Cisco AS5800 Universal Access Server supports online insertion
and removal (OIR). This feature allows you to remove and replace a
dial shelf controller card or feature card (trunk card or modem card)
while the system is operating without affecting system operation.
RJ­45 TE
Pin
Shield
<— J2­1
<— J2­2
J2­3
—> J2­4
—> J2­5
J2­6
RJ­45
NT
Pin
Ground Shield
TX Tip J2­4
TX J2­5
Ring
TX J2­6
Shield
RX Tip J2­1
RX J2­2
Ring
RX J2­3
Shield