TrekStor DataStation Pocket Capa User Manual page 11

Table of Contents

Available languages

Instructions for safety and use:

Only qualified persons may perform technical work on the product. The product may not be opened

or changed. The components cannot be serviced by the user.

Never expose the device to moisture, condensation and liquids.

Protect the device from extremely high and low temperatures and temperature fluctuations. Use the

device within an ambient temperature of 10ºC to 40ºC.

Never place the device close to a source of heat, and protect it from direct sunlight.

Make sure that the surroundings are as dust-free as possible when you use and store the device.

Never clean the surface of the device with solvents, paint thinners, cleansers or other chemical

products. Instead, use a soft, dry cloth or soft brush.

In case you are using your DataStation pocket in connection with a thin USB cable or an USB cable,

which is longer than 1 m, malfunctions or defects of your DataStation pocket may be the result.

Therefore, please always use the USB cable, which is included in the delivery. Connect the USB cable

always without a USB extension directly to your PC.

In certain circumstances, exposing the device to an electrostatic discharge may interrupt the data

transfer between the device and the computer and impair the functions of the device. If this occurs,

the device should be unplugged from the USB port and then plugged in again.

The capacity indicated by your operating system can be different than the actual capacity of your

external hard drive. Like most manufacturers of computer hardware, TrekStor uses the prefixes for units

(e.g. 1 GB = 1.000.000.000 bytes) as prescribed by the International System of Units (SI). Unfortunately,

many operating systems do not comply with this norm and display a lower capacity because they

base their calculations on the assumption that 1 GB = 230 bytes = 1.073.741.824 bytes.

The manufacturer retains the right to continually improve the product. These changes may be made

without being directly described in these operating instructions. For this reason, the information provided

in these operating instructions may not reflect the current state of the art.

The manufacturer only guarantees suitability for the product's intended purpose. In addition, the

manufacturer is not responsible for damages or loss of data and subsequent consequences.

trademarks or brand names of the respective owner.

Table of Contents