ZIGBEE In-wall Switch Manual

AC ZigBee In-wall Switch
Important: Read All Instructions Prior to Installation
Function introduction
"Reset" Key: for
network pairing,
touchlink, factory
reset of the switch,
Reset
turn on/off the load
AC 100-240V
OUT
L L
1 CH 100-240VAC output
Product Data
Input Voltage Output Voltage
100-240VAC 100-240VAC
Compatible Load Types
Load Symbol Load Type
LED lamps with transformers
LED drivers
Incandescent lighting,
HV Halogen lamps
Low voltage halogen
lighting with electronic
transformers
09.ZG09SAP.04736
A1-A2: 8-230V
LED indicator
N
N N L
AC 100-240V power input
Output Current Size(LxWxH)
1.5A max 45.5x45x20.3mm
Maximum Load Remarks
Due to variety of LED lamp
designs, maximum number
200W @ 220V of LED lamps is further
100W @ 110V dependent on power factor
result when connected to
switch.
Maximum permitted number
200W @ 220V
of drivers is 200W divided
100W @ 110V
by driver nameplate power
rating.
400W @ 220V
200W @ 110V
200W @ 220V
100W @ 110V
• ZigBee in-wall switch based on latest ZigBee 3.0 protocol
• 100-240VAC Wide Input and Output Voltage
• Supports resistive loads and capacitive loads
• 1 Channel Output, Up to 400W
• Input and Output with Screw Terminals, Safe and Reliable
• Enables to control ON/OFF of connected load
• ZigBee end device that supports Touchlink commissioning
• Can directly pair to a compatible ZigBee remote via Touchlink without coordinator
• Supports self-forming zigbee network without coordinator and add other devices to the network
• Supports find and bind mode to bind a ZigBee remote
• Supports zigbee green power and can bind max. 20 zigbee green power remotes
• Compatible with universal ZigBee gateway products
• Can be controlled by universal 8-230V input single wire push switch
• Mini Size, Easy to be Installed into a standard 86*86mm wall box
• Radio Frequency : 2.4GHz
• Waterproof grade: IP20
Safety & Warnings
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
ZigBee Clusters the device supports are as follows:
Input Clusters
0x0000: Basic 0x0003: Identify 0x0004: Groups
0x0b05: Diagnostics
Output Clusters
0x0019: OTA
Operation
1.Do wiring according to connection diagram correctly.
2.This ZigBee device is a wireless receiver that communicates with a variety of ZigBee compatible systems. This
receiver receives and is controlled by wireless radio signals from the compatible ZigBee system.
3. Zigbee Network Pairing through Coordinator or Hub (Added to a Zigbee Network)
Step 1: Remove the device from previous zigbee network if it has already been added to, otherwise pairing will
fail. Please refer to the part "Factory Reset Manually".
Step 2: From your ZigBee Controller or hub interface, choose to add lighting device and enter Pairing mode as
instructed by the controller.
Step 4: Connected light will blink 5
times and then stay solid on, then the
device will appear in your controller's
menu and can be controlled through
controller or hub interface.
0x0005: Scenes 0x0006: On/off
A1-A2: 8-230V
Step 3: Re-power on the device to set
Reset
it into network pairing mode
N
AC 100-240V
(connected light flashes twice
OUT
L L N N
L
slowly), 15 seconds timeout, repeat
the operation.
AC Power
50/60Hz