Table of Contents
Advertisement
Quick Links
05/07/2012
Ins-30175 Net2Air Ethernet bridge in plastic housing
Technical Support
01273 811011
Technical help is available:
Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/
Enclosure
Net2Air wireless communication
The access control unit connects to the Net2 system using Paxton Net2Air proprietary wireless technology through
a Net2Air bridge.
Radio signals do not always behave as you might expect. For example, a mobile phone that displays a full signal
on one part of the site will lose signal completely only a few metres away. These problems can be addressed by
using the Net2 site surveyor kit (690-200).
See also:
XAN1095 - Net2 wireless access control - How does it work? < http://paxton.info/974 >
X
AN1096 - How to plan a Net2 wireless installation < http://paxton.info/975 >
X
Ins-30096 - Net2Air site surveyor < http://paxton.info/1015 >
Radio frequency
This product should not be installed within 3 metres of other wireless equipment operating on a 2.4Ghz frequency.
To ensure optimum performance other wireless networks should avoid WiFi channels 1, 2 and 3 to reduce the
possibility of interference.
Net2Air Site Surveyor (690-200).
This access control unit uses wireless communication. It is recommended that a Net2Air site surveyor is used
to determine the best position for the bridge and control units.
support@paxton.co.uk
Monday - Friday from 07:00 - 19:00 (GMT)
Saturday from 09:00 - 13:00 (GMT)
Software - Requires Net2 v4.14 or later.
Paxton
Advertisement
Table of Contents
Related Manuals for Paxton Net2Air
Summary of Contents for Paxton Net2Air
-
Page 1: Technical Support
To ensure optimum performance other wireless networks should avoid WiFi channels 1, 2 and 3 to reduce the possibility of interference. Net2Air Site Surveyor (690-200). This access control unit uses wireless communication. It is recommended that a Net2Air site surveyor is used to determine the best position for the bridge and control units. - Page 2 DHCP servers are not guaranteed to be constant, leading to potential failure of communication between Net2 software and the bridge. Run the Net2 Server Configuration Utility (Start/Programs/Net2) and Click on Net2Air Bridge. Click on;Detect and the MAC address of the device(s) will appear in the table. You must then use the "IP address configuration"...
-
Page 3: Led Indications
TCP/IP LAN communicating with the PC Net2 server connection Net2Air wireless activity (Tx/Rx) - Blue Data Reset To clear all settings back to their factory default, including clearing the current IP address and setting the bridge to acquire new addresses using DHCP, power on the unit with the reset button held down for 3 seconds.
Need help?
Do you have a question about the Net2Air and is the answer not in the manual?
Questions and answers