Table of Contents
Advertisement
Quick Links
01/28/2013
Ins-40085-US Net2Air Ethernet bridge - UL
Technical Support
1.800.672.7298
Technical help is available:
Documentation on all Paxton products can be found on our web site - http://www.paxton-access.com/
Net2Air wireless communication
The access control unit connects to the Net2 software running on the PC using Paxton Net2Air proprietary wireless
technology. A Net2Air bridge enables communication from the Net2 software to the Paxton wireless products.
Radio signals do not always behave as you might expect. For example, a cell phone that displays a full signal on
one part of the site will lose signal completely only a few feet away. These problems can be addressed by using the
Net2 site surveyor kit (690-200-US)
See also:
XAN1095 - Net2 nano - How does it work? < http://paxton.info/974 >
X
AN1096 - How to plan a Net2 nano installation < http://paxton.info/975 >
X
Ins-30096-US - Net2Air site surveyor < http://paxton.info/1193 >
Radio frequency
This product should not be installed within 10 feet of other wireless equipment operating on a 2.4Ghz frequency.
To ensure optimum performance other wireless networks should avoid WiFi channels 11, 12 and 13 to reduce the
possibility of interference.
This unit is for supplemental use only, and is to be employed as a programming/downloading/monitoring tool only.
The unit will continue to operate in a 'standalone' mode if the PC is shut down. Any Events that occur during this
period are stored in the unit and the PC is updated when it comes back on line.
Part number
477-384-US
Please contact your IT Administrator before installing this product.
For instructions in alternative languages - http://paxton.info/1000
Net2Air Ethernet bridge
**IMPORTANT - THIS IS A NETWORK DEVICE**
supportUS@paxton-access.com
Monday - Friday from 02:00 AM - 8:00 PM (EST)
Options
Description
Net2Air Ethernet bridge
Paxton
Reader
Control unit
PAGE 1
Advertisement
Table of Contents
Related Manuals for Paxton Net2Air Ins-40085-US
Summary of Contents for Paxton Net2Air Ins-40085-US
- Page 1 For instructions in alternative languages - http://paxton.info/1000 Net2Air wireless communication The access control unit connects to the Net2 software running on the PC using Paxton Net2Air proprietary wireless technology. A Net2Air bridge enables communication from the Net2 software to the Paxton wireless products.
- Page 2 Following the completed installation of this equipment, no further maintenance or testing is required. It is advisable to ensure that any third party backup power supplies or recovery procedures are checked regularly to ensure that the operation of the Paxton system is not compromised. PAGE 2...
- Page 3 This unit is designed to connect to an Ethernet port and supply the data at the required communications protocol necessary for Paxton Net2 equipment. The unit is supplied in a plastic housing with a clip-on mounting (See Enclosure section). Suitable fasteners; two screws and wall plugs are also provided if the base is to be fixed to a wall or ceiling.
- Page 4 When connecting to a WAN or different subnet mask If you are connecting this device to a remote subnet which is different from the Net2 software PC, the standard detect mechanism cannot work across the network routers between them. The IP address, along with the correct subnet mask and gateway for the remote subnet have to be set.
Need help?
Do you have a question about the Net2Air Ins-40085-US and is the answer not in the manual?
Questions and answers