Silent Operation - Carrier 30AWH-025QI User Manual

Domestic hot water tank temperature Setting
Inverter Hybrid Boiler
Room
Repeat
Silent
Time
Smart
Registration
Repeat time operation
Inverter Hybrid Boiler
Room
Repeat
Silent
Time
Smart
Registration

Silent operation

This function restricts the revolutions of the compressor.
Inverter Hybrid Boiler
Room
Repeat
Silent
Time
Smart
Registration
12
Inverter Hybrid Boiler
● To set the domestic hot water tank temperature, press the DHW
button first, and press the TEMP/TIME adjust buttons (▲, ▼) to
adjust the temperature setting.
- You can adjust the temperature setting by 1℃ per one time
pressing in a range from 35 to 80℃.
- How to set the domestic hot water tank temperature
: When you push the DHW button, a "
Thermal Storage
Tank
: The "
Outing Cancel
WPS Network
RST
- Adjust the domestic hot water temperature depending on the
season as appropriate.
The repeat time operation means the function that sets the
operation and stop time of the heating pump by a consumer.
- To set the interval, press the REPEAT button, and then press the
--TEMP/TIME adjust button to adjust the time interval.
- When you push the REPEAT button, the
- You can set the repeat interval as follows:
Press the REPEAT button → The segment(
Thermal Storage
Tank
flickers at a 1-second interval → Set the desired heating pump
Outing Cancel
WPS Network
RST
the (▲, ▼) buttons → Press the REPEAT button again (setting
- You can adjust the operation and stop time setting range from 0 to
- If you press the CANCEL button during Repeat Time mode or while
setting the Repeat Time, the settings you've changed are canceled.
● When you press the SILENT button, the revolutions of the
compressor are limited to 70rps.
- "
- Silent mode is canceled when you press the SILENT
button again or press the CANCEL button while in silent
mode.
Thermal Storage
Tank
Outing Cancel
WPS Network
RST
promted, and the temperature reading flickers at a 1-second
interval.
" display disappears 3 seconds after the setting is
completed and the " " display is activated.
In addition, the temperature displays the current domestic hot
water tank temperature.
is prompted and flickers at a 1-second interval and the "
signal appears on the operating mode display.
operation time using the (▲, ▼) buttons → Press the REPEAT
button again → The segment(
1-second interval → Set the desired heating pump stop time using
complete)
99 minutes. If your input exceeds the adjustable range, the value
starts from 0 again.
" appears on the operating mode display.
" display is
display
"
) of the operation( )
) of the stop( ) flickers at a