Heating Operation; Room Temperature Settings - Carrier 30AWH-025QI User Manual

Heating operation

This function increases the flow temperature in the indoor unit (hydro unit).
It provides heat to indoors through the floor heating coil or radiators.
Inverter Hybrid Boiler
Thermal Storage
Room
Tank
Repeat
Silent Outing Cancel
Time
Smart
WPS Network
Registration
RST
- Heating operation will not be activated when the desired temperature is set below the
current temperature reading.
- Default setting of room temperature and the domestic hot water tank temperature are
Reference
25℃ and 80℃, respectively.
- Automatic heating operation refers to the operation of the heating system which selects
the operating mode (heating, thermal storage, thermal storage and heating at the same
time) based on the automatic detection of the domestic hot water tank temperature and
the room temperature by the system itself.

Room temperature settings

This function sets the desired room temperature. The current room temperature is displayed
3 seconds after changing the room temperature settings.
Inverter Hybrid Boiler
Thermal Storage
Room
Tank
Repeat
Silent Outing Cancel
Time
Smart
WPS Network
Registration
RST
● The automatic heating operation is activated when pressing
the ON/OFF( ) button.
● The operation stops when you press the ON/OFF(
button once again during operation.
(However, when heating pump is controlled by existing
remote controller of existing electric heater boiler, only the
Thermal storage operating is running)
● To set the room temperature, press the ROOM button first,
and then press the TEMP/TIME adjust buttons (▲, ▼) to
adjust the temperature settings.
(only available in an indoor environment where a wired
remote controller is installed)
- You can adjust the temperature setting by 1℃ per one
time pressing in a range from 17 to 30℃.
- How to set the room temperature
: When you push the Room button, a "
prompted, and the temperature reading flickers at
1-second intervals.
: The " " display disappears 3 seconds after setting is
completed and the "
In addition, the temperature displays the current room
temperature.
" display is
" display is activated.
User's Manual
)
11