Download Print this page
JABSCO 18590 Series Manual

JABSCO 18590 Series Manual

Self-priming macerator pump

Advertisement

Quick Links

SELF-PRIMING
MACERATOR PUMP
FEATURES
Pump:
Self-Priming Flexible Impeller with
Stainless Steel Wearplate
Impeller:
Jabsco Nitrile compound
Macerator:
Stainless Steel Cutter reduces particle
size to 1/8" (3mm) maximum
Seal:
Lip Type
Ports:
Inlet - 1-1/2" (38mm)Hose Barb
and 1-1/2" N.P.T. (Male)
Outlet - 1" (19mm) Hose Barb
Motor:
Permanent Magnet Type, Fully
Enclosed, with Stainless Steel Shaft
Complies with USCG Regulation 183.410
and ISO 8846 MARINE for Ignition
Protection
Weight:
5 lb (2,3 kg) Approx.
VARIATIONS AVAILABLE
MODEL NO.
DESCRIPTION
18590-0000 12 Volt
18590-0090 12 Volt EMC
18590-0001 24 Volt
18590-0091 24 Volt EMC
APPLICATION
The JABSCO 18590 series dc macerator pump unit is the
ideal solution for emptying marine holding tanks when not
in a discharge restricted area. The JABSCO macerator is
self-priming to a five foot lift when impeller is wet, four foot
when dry, and may be mounted in any convenient point in
the waste discharge system. The macerator section grinds
waste down to a particle size of 1/8" (3mm) maximum so it
can easily by pumped through a 1" (19mm) ID discharge
hose. The pump section is self-priming, permitting the unit
to be mounted above the tank in a convenient location.
(For optimal efficiency, locate pump as close to holding
tank as possible.)
The macerator has an approximate flow rate of 12 GPM
(45 LPM) and will empty a typical 30 gallon (115 litre) hold-
ing tank in less than 3 minutes.
The 18590 series waste pump will macerate and pump all
waste and tissue normally found in marine and recreational
vehicle waste systems.
Model 18590-Series
The pumps should be used in accordance with EPA,
USCG Marine Sanitation Regulations, and any regional
or local ordinances.
Motors meet USCG Electrical Regulation Title
33, Chapter 1, Part 183; Subpart 1 and ISO
8846 MARINE for IGNITION PROTECTION.
OPERATING INSTRUCTIONS
The macerator should be controlled by a momentary
switch (push and hold) positioned close enough to the
pump so it can be heard while operating. When the tank is
empty there will be a change in pump noise (louder, high-
er frequency) at which time the macerator should immedi-
ately be switched off.
The macerator pump unit has been designed to handle
waste, toilet tissue, and facial tissue. It will also handle
longer than 30 seconds or impeller and pump damage
may result. Make sure the battery is ful!y charged. The dc
motor is suitable only for intermittent duty and should not
be run for more than 15 minutes continuously. At maxi-
mum flow of 12 GPM (45 LPM) the macerator can empty
a 180 gallon (680 litre) holding tank in a single operation.
solids such as cigarettes,
cigars and chunks of soft
fruits or vegetables less
than 1" size. It will not
pump solid objects like
fruit
pits,
rags,
wet
strength kitchen towels,
tampons or sanitary nap-
kins. The holding tank and
pump should be flushed
with several gallons of
water after each pumpout.
Do NOT run pump dry

Advertisement

loading

Summary of Contents for JABSCO 18590 Series

  • Page 1 APPLICATION waste, toilet tissue, and facial tissue. It will also handle solids such as cigarettes, The JABSCO 18590 series dc macerator pump unit is the cigars and chunks of soft ideal solution for emptying marine holding tanks when not fruits or vegetables less in a discharge restricted area.
  • Page 2 Use stranded copper wire of the correct size (determined INSTALLATION INSTRUCTIONS from the electrical specifications chart) to connect the Locating the Pump: The JABSCO macerator is self-priming macerator to the power source. Undersized wire will to a five foot lift when impeller is wet, four foot when dry,...
  • Page 3 EXPLODED VIEW PARTS LIST impeller (Key 8), small wearplate (Key 9), two studs and shaft seal as an assembly off the motor shaft and remain- PART ing two mounting studs. Remove the starlock retaining DESCRIPTION NUMBER washer on the seal and push the seal out of the seal bore. Acorn Nut 91085-0340 Notice: If reconditioning pump with a service kit (Part No.
  • Page 4 1-3/4 2-3/32 (44) (53) 7-11/32 4-5/32 (51) (187) (106) THE PRODUCTS DESCRIBED HEREIN ARE SUBJECT TO THE JABSCO ONE YEAR LIMITED WARRANTY, WHICH IS AVAILABLE FOR YOUR INSPECTION UPON REQUEST. U.S.A. UNITED KINGDOM CANADA JAPAN GERMANY Jabsco Jabsco Fluid Products Canada NHK Jabsco Company Ltd.

This manual is also suitable for:

18590-000018590-009018590-000118590-0091