Belt Service; Engine Drive Belt Replacement - Snapper CP215520HV Safety Instructions & Operator's Manual

Maintenance (Continued)
!
WARNING
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.
Replacing the Bearing On the Pulley End Of the
Hex Shaft
To replace the bearing on the pulley end of the hex shaft,
proceed as follows:
1. Hold the hex shaft with an adjustable wrench held next
to the pulley.
2. Remove the 3/8" hex lock nut (B, Figure 34), located on
the outside of the right wheel bracket.
3. Remove the holder (A), O-ring (C) and bearing (D).
4. Install the new bearing.
5. Carefully install the new O-ring over the outside of the
new bearing.
6. Install the bearing holder, and secure with screws.
7. Install the 3/8" hex lock nut.
D
B
Figure 34: Replacing the hex shaft bearing
18
!
C
A

Belt Service

On self-propelled mowers, the engine belt (A, Figure 35)
transmits power from the engine pulley (B) to the drive disc
(C). The drive disc powers the poly-v belt, which engages the
transmission that powers the rear wheels. Should these belts
become worn, they could cause slippage, which would
impair mower performance. The condition of the engine belt
and poly-v belt should be checked after every 25 hours of
mower operation.
Engine Drive Belt Replacement (Stretch Type
Belts)
1. Empty the fuel tank.
2. Note the belt routing (Figure 35). There is no idler
pulley on these models to disconnect.
B
Figure 35: Engine drive belt routing
A
C
www.snapper.com