INDEX Congratulations Warnings/Safety measures/Maintenance Parts Installation Adjusting Safety Harness Disassembly safety harness/further use of the highchair Warranty IMPORTANT! RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AND READ CAREFULLY...
KIDSMILL HIGHCHAIR UP! CONGRATULATIONS Congratulations on the purchase of this Kidsmill Up! Highchair. This product meets the most stringent safety requirements and is approved according to the Australian Standard AS 4684:2009. Using this highchair can only be safe when used according to these instructions. Please read this instruction manual carefully and store it for future reference.
INSTALLATION 4. (2x) 3. (2x) 2. (5x) 1. (2x) Step 1: Fix the connection bars (9+10), backrest(13), safety and the metal tension rod(11) on the chair leg(7). Attention! Tighten all screws by hand. Step 2: Fix the second chair leg(8). Attention! Tighten all screws by hand.
Page 6
INSTALLATION Step 4: Place the seat(15) with the curved corners against the legs. Step 3: Slide the seat(15) and the footrest(14) into the grooves at the desired height. To mount the safety bar between the legs, pull the legs outwardly. 6.
ADJUSTING SAFETY HARNESS Step 3: Adjust the size of the safety Step 4: Push the buckle parts to harness to the size that fits for your release the safety harness. child.
DISASSEMBLY SAFETY HARNESS/FURTHER USE OF THE HIGHCHAIR Step 2: Turn around the seat(15). Step 1: Remove the seat(15) by loosening the metal tension bar(11). Step 3: Remove the screws by using the screwdriver.
Page 9
DISASSEMBLY SAFETY HARNESS/FURTHER USE OF THE HIGHCHAIR Step 4: Pull the crotch strap away from the seat(15). Step 5: Remove the D-ring from the crotch strap and now you are able to remove the crotch strap from the seat(15). Step 1: Adjusting the seat(15) and footrest(14) can be done by the loosening and tightening of the metal tension bar(11).
WARRANTY Validity: 2 years from date of purchase. The warranty is only valid in conjunction with proof of purchase. The warranty covers the replacement of the entire product or parts when there a manufacturing defect. After the expiration of the warranty there are costs attached to any repairs. The supplier takes no responsibility for any damage or injury to persons, animals and belongings due to misuse of the harness or by failure to follow the accompanying instructions.
Page 11
WARRANTY FORM EN - In case of damaged or missing parts, please fill in this form and send Anstel Nominees Pty Ltd to the following E-mail address: Service department nfo@kidsmill.com.au Product: ..............Article number: ..............Serial number: ............... Part number (p. 4)
Page 12
The information contained herein is subject to change without notice. Timgro BV shall not be liable for technical errors or omissions contained herein. The purchased product may differ from the product as described in this user guide. Anstel Nominees Pty Ltd 36 Sunline Drive Truganina VIC 3029 Australia e-mail: info@kidsmill.com.au Version: August 2018...