Mode; Reboot System; System Info - KB VISION KX-DR01 User Manual

Sub Mask：
Gateway：
System prompts setup is successful.

4.4.3 Mode

The device suppers two work mode, including "this device as controller and "this device as
card reader".

This device as controller: the device is used as an A&C controller for unlock
operation.

This device as card reader, the device is used as a card reader, if you need to control
door unlock, then it must be connected to an A&C controller before it can be used.
To set device mode:
Step 1. In system setup interface, press 【↑】key or 【↓】key, select mode setup, and
press 【√】key.
Step 2. Select work mode, and press 【√】.
Step 3. Press【↑】key or 【↓】key, select work mode, and press 【√】 key as follows.
After selection is successful, a ○ √ will be shown next to work mode.

4.4.4 Reboot System

To reboot the system:
Step 1. In main interface, press 【↑】or【↓】key, select system reboot, and press【√】.
System asks if to reboot or not.
Step 2. Select YES, and press【√】key to reboot.

4.5 System Info

You can view device card swiping info, alarm info and local info.
IP Setup
IP： 172.7.10.33
255.255.255.0
172.7.0.0
Work Mode
This device as controller
This device as card reader
○
√
17