Environmental Conditions; Mechanical Specifications; Rf Exposure Warning - Dekolink MW-CBDA-SMR-800-900-1W65 Installation And Operating Instructions Manual

Environmental Conditions

The unit is designed for indoor applications:
Operating temperature
Storage temperature
Mechanical Specificatios
Size
RF Connectors
Weight

RF Exposure Warning

In order to satisfy the FCC RF exposure requirements, you must ensure that the installation complies
with the following:
One antenna is connected via cable that has typical 1~10 dB attenuation (depends on the length of the
cable) to the CBDA BASE port. This antenna is installed outdoor and has very sharp beam (Yagi type or
similar) pointed to the donor (BTS). This type of antenna has about 10 dBi gain. Typical specifications:
gain: 8 dBd (=10.1 dBi), VSWR: better than 1.5:1 , Impedance: 50 ohm. The outdoor antenna must be
installed to provide a minimum separation distance of 0.5 m (50 cm) from persons within the area.
The second antenna is connected via cable that has typical 1~10 dB attenuation (depends on the length
of the cable) to the CBDA MOBILE port. This type of antenna is omni-directional (isotropic), or wide
beam, with 0 to 2 dBi typical gain and is installed and distributes indoor (in buildings, tunnels,
basements, park lots, shopping centers etc.). Typical specifications: gain: 2 dBi, VSWR: better than 2:1 ,
Impedance: 50 ohm. The indoor antenna must be installed to provide a minimum separation distance of
0.2 m (20 cm) from persons within the area.
Dekolink Wireless Ltd.;16 Bazel St.Qiryat-Arieh Petah-Tikva Israel, 49510
Tel- 972-3-9180-180; Fax-972-3-
Web site-
www.dekolink.com
- 50
10.6 x 10 x 6.8 inch approx.
(270 x 250 x 172) mm approx.)
N-type Female
17.6 Lbs. (8 kg.) approx.
9180 - 190 ; Email-marketing@dekolink.com;
r
ev 0 11/
04
° °
0 C to + 50 C
° °
C to + 80 C
page 14 of 16