Replacing The Lamp - AEG S72388SK1 User Manual

14
What to do if...
Problem
Water flows on the
ground.
The temperature in the
appliance is too cold.
The temperature in the
appliance is too warm.
The temperature in the
refrigerator is too warm.
The appliance does not
operate.
The lamp does not work.
Door interferes with ven-
tilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

1. Disconnect the appliance from the power socket.
Possible cause
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly. Refer to "Closing the door".
The food temperature is too
high.
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The door has been open to long. Close the door.
The appliance is not levelled.
The appliance is not levelled.
Solution
Attach the melting water outlet
to the evaporative tray.
Set a warmer temperature.
Set a lower temperature.
Let the food temperature de-
crease to room temperature be-
fore storage.
Make sure that there is cold air
circulation in the appliance.
Insert smaller quantities of food
to be cooled at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a another electrical ap-
pliance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Replacing the lamp".
Refer to "Levelling".
Refer to "Levelling".