The drying cycles are automatically fol-
lowed by an anti-crease phase which
lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free from
creases. The laundry can be removed
at any time during the anti-crease
phase. (The laundry should be taken
out towards the end of the anti-crease
phase at the latest to prevent creases
from forming.) If long anti-crease
tion has been set, the anti-crease
phase is lengthened by 60 minutes.
1. Open door.
CARE AND CLEANING
Cleaning fluff filter
The filters collect all the fluff which accumu-
lates during drying. To ensure that the dryer
works perfectly, the fluff filters (micro-fine fil-
ter and fine strainer) must be cleaned after
every drying cycle.
The warning icon
Caution! Never operate the dryer
without fluff filters or with damaged or
blocked fluff filters.
Open loading door
2. Use a damp hand to clean the micro-
fine filter, which is built into the lower
part of the loading aperture.
is on to remind you of
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best to
use a damp hand for this purpose. (See
"Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
After a period of time, a patina due to
detergent residue on laundry forms on
the filters. When this occurs, clean the
filters with warm water using a brush.
Remove the filter from the door pulling
it out. It can be positioned with the
tooth facing to the left or to the right).
After cleaning do not forget to put it