Sony VGP-WMS20 Instruction Manual

VGP-WMS20
Instruction Guide
Your VGP-WMS20 provides unrivaled precision and convenience.
To begin using your VGP-WMS20, you will need to:
1. Install the batteries
2. Plug the USB Wireless Receiver into a USB port on your computer.
3. Push the button of receiver and the connect button of mouse.
The VGP-WMS20 will then be ready to use.
Declaration of Conformity Compliance Statement for the Sony VGP-WMS20
The Wireless Laser Mouse VGP-WMS20 complies with Part 15 of the FCC Rules. Operation is
subject to two conditions: 1.This device may not cause harmful interference, and, 2. this device
must accept any interference received, including interference that may cause undesired operation.
As defined in Section 2.909 of the FCC Rules, the responsible party for this device is Sony
Corporation 6-7-35 Kitashinagawa Shinagawa-ku, Tokyo, 141-0001 Japan.
International Standards and Safety:
This laser device complies with International Standard IEC 60825-1:2001-08, Class 1 Laser
Product and also complies with 21 CFR 1040.10 and 1040.1, except for deviations pursuant to
laser Notice Nr. 50, dated Jul 26, 2001:
1. Emission of a parallel beam of infrared user-invisible light;
2. Maximum Power of 716 microwatts CW, wavelengths range 832-865 nanometers;
3. Operating temp between 0°C 32°F to 40°C 104°F.
CAUTION: This device has no serviceable parts. Use of controls or adjustments or performance
of procedures other than those specified herein may result in hazardous radiation exposure.
Safety and Usage Guidelines
1. In the absence of proper operation and if customer initiated troubleshooting is unsuccessful,
switch off device and call Sony technical support.
2. Do not disassemble product or expose it to liquid, humidity, moisture or temperatures outside
the specified operating ranges of 0°C 32°F to 40°C 104°F.
3. If your product is exposed to out of range temperatures, switch it off and allow temperature to
return to the normal operating range.
RF Technical Specifications
Multi-Channel RF Frequency 2.402 GHz
Federal Communications Commission Radio Frequency
Interference Statement
Note: The Sony VGP-WMS20 has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment causes harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: