AEG FAVORIT 55010 User Manual page 22

22
What to do if...
Malfunction
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
Possible cause
The delay start is set.
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener ad-
justment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
Possible solution
• Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatical-
ly.
Possible solution
Make sure that the washing
programme is applicable for
the type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt con-
tainer cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.