Setup Instructions - GLOW EZ Lock Deep Parabolic Softbox Manual

Setup Instructions

1. Remove the EZ Lock Parabolic Softbox from the carrying case.
2. Rest the back of the Parabolic Softbox, the Bowens speedring, on a
flat surface and gently spread out the aluminum rods that support the
silvered fabric material.
3. Grasp the aluminum EZ Lock mechanism that is suspended, unlocked,
on the center umbrella shaft.
4. Press down on the EZ Lock ring to slide it down to mate with the hub
of the rod spokes, until it is firmly seated with a click. The EZ Lock
automatically latches, with the button out, when it is the proper position.
5. The Parabolic Softbox is now fully opened and correctly constructed.
Unzip the slit on the side of the softbox, reach inside, and grasp the
speedring insert and the softbox firmly. Align the mount to mate with
your flash and lock into place according to the flash manufacturer's
instructions, or replace the adapter to match the strobe of choice from
the wide variety of Glow 144mm speedring inserts.
6. Attach the deflector disc. This step must be accomplished after the
Parabolic Softbox is assembled and EZ Locked. The softest effect is
reached with the plate in position. The plate is reversible to achieve a
variety of properties.
A. Hold the disk concave profile up to control the center hotspot and
spread the light about the softbox. By reversing the deflector disk
and changing the position of placement on the shaft, the light
spread is customizable.
B. Slide the cap on the center shaft.
C. Center the plate hole in the shaft and Press the EZ Lock downward
on the shaft until it meets the hub. The rubber ring will keep the
cap in the place of your choice.
4
GlowLightControl.com