Vinotemp VT-6TED-WB Owner's Manual page 11

Wall-mounted wine cooler
Hide thumbs Also See for VT-6TED-WB:
Table of Contents

Advertisement

Do not connect or disconnect the electric plug
when your hands are wet.
Do not store chemicals in or near your wine
cooler. Be especially mindful that the rear of your
wine cooler is the hottest part.
Do not place any electrical appliance on top of
your wine cooler.
Do not try to force the chrome shelves out from
your wine cooler. To remove the shelves, always
pull them out gently, and be careful of
obstructions (particularly the gasket seals).
Never close the door forcefully. The performance
of the hinge may suffer if the door is slammed
shut.
Never use oil to lubricate the hinge as it may
seep down and subject the rubber seal to
cracking.
Never clean appliance parts with flammable
fluids. These fumes can create a fire hazard or
explosion.
Do not use solvent-based cleaning agents or
abrasives on the interior. These cleaners may
damage or discolor the interior.
Remember, your wine cooler can only cool wine bottles if the room's ambient temperature is
between 50˚-80˚F. If the ambient temperature drops below the set temperature, the wine cooler
will chill to match the ambient temperature. This can run the risk of freezing, so make sure that
you have taken a room's temperature range into account before you install your wine cooler.
POWER FAILURE
If a power failure occurs, avoid opening the door. Most power failures are corrected within a few hours
and should not affect the temperature of your appliance if you minimize the number of times the door
is opened. If the power is off for an extended period of time, proper steps should be taken to protect
your contents.
INACTIVITY
If the unit will not be used for a period of less than three weeks, leave the cooler operating. If the
period of inactivity is several months, remove all items and turn the unit off. Clean and dry the interior
thoroughly. Leave the door open slightly to prevent any possible moisture build-up.
MOVING YOUR WINE COOLER
Before moving your cooler, first be sure to remove all items from the cooler.
Always unplug the cooler before moving.
Use two or more people to move and install the appliance. Failure to do so can result in back or
other injuries.
Securely tape down any loose items, such as shelves, inside the unit.
Tape the door shut.
Ensure that the unit stays securely in the upright position during transportation.
Protect the outside of the appliance with a blanket or similar item.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
11
1
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents