Dacor IF42 Series Planning Manual

EF42DBSS, EF42NBSS, EF48DBSS, EF48NBSS,
IF42DBOL, IF42NBOL, IF48DBOL, IF48NBOL
Revised
04/22/08
O D
pening imensiOns
◊ To avoid tipping during use, the solid soffit must be within 1"
(2.5 cm) maximum above the refrigerator. If the solid soffit
is higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80" to 90" (203 cm to 229 cm) above the floor.
See installation instructions for more information.
NOTE: A clearance of ¹⁄
the top grille in order for the top grille to be removed.
◊ A grounded 3 prong electrical outlet should be placed within
4" (10.2 cm) of the right side cabinets or end panel. See
Electrical Requirements for more information.
◊ The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. If the water shutoff valve is not in the cabinets, the
plumbing for the water line can come through the floor or
the back wall. See Water Supply Requirements for more
information.
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
42" and 48" Wide
Built-In Refrigerators
" (1.3 cm) must be maintained above
2
/ "
1
2
(1.3 cm)
¹/
83 " (212.1 cm) min.
2
³/
84 " (215 cm) max.
4
to bottom of solid soffit
(60.96 cm) min.
Model Series
EF42, IF42 41½" (105.4 cm) to 41¾" (106.1 cm)
EF48, IF48 47½" (120.7 cm) to 47¾" (121.3 cm)
NOTE: Flooring under refrigerator must be at same level as the
room. Face of cabinetry must be plumb.
Specifications are subject to change without notice.
See installation instructions for additional details.
PLANNING
GUIDE
1/6
4"
(10.2 cm)
77"
(196 cm)
A
Width
(see chart following)
24"
See Page 11.15
Cutout Width A
11.14