Snooze Setting; Setting The Sleep Timer - Nero 743191 Instruction Manual

Notes
⚫
The ALARM 1 (or 2) indicator flashes in the display when the alarm sounds.
⚫
If a later alarm starts to sound when the earlier alarm still sounds, then the later
alarm takes priority.
⚫
If a later alarm sounds when the earlier alarm is under SNOOZE period, then the
later alarm takes priority and will cancel the SNOOZE function of the earlier
alarm automatically.
⚫
If the same time is set for both alarm (ALARM 1 or 2). The ALARM 2 takes
priority.

SNOOZE SETTING

Once the alarm is activated, the snooze function can be used to stop the alarm
temporary for about 9 minutes and then alarm will sound again.
1) Once alarm (either Alarm 1 or Alarm 2 ) sounds, press the SNOOZE button (9), the
buzzer or radio alarm sounds will stop and will sound again after 9 minutes. The
SNOOZE function can maintain valid within 1 hour from the set alarm time.
2) During the time when SNOOZE function is activated, the alarm indicator will
flash.
3) To switch off the SNOOZE function, press ON/OFF button (3). You can then see
the alarm indicator stop flashing, and the alarm will not sound again after the
snooze period elapse.

SETTING THE SLEEP TIMER

The sleep function allows the radio to play in blocks of 10, 20, 30, 40, 50, 60, 70, 80,
or 90 minutes before turning off automatically, then you can enjoy falling asleep
when listening the radio.
1) Turn on the radio.
2) Press the SLEEP button (9), then the LED shows 90 (for 90 minutes ).
3) Press the SLEEP button (9) repeatedly until the display shows the desired SLEEP
time period. The time period is shown on the display in sequence as 90 > 80 >
70 > 60 > 50 > 40 > 30 > 20 > 10 > OFF.
4) In 2 seconds after the desired SLEEP period is chosen, the display will change to
show the current time, and the radio will play for the SLEEP time duration you
have set and then be turned off automatically.
5) Press the SLEEP button (9) again during SLEEP mode, the LED will show
the remaining time of the SLEEP period, and the SLEEP time can be set again