Operating The Radio - Nero 743191 Instruction Manual

the AC cord from AC outlet and remove the battery.

OPERATING THE RADIO

1. Press the ON/OFF button (3) once to turn on the radio. The radio receives in
the FM band with the FM indicator (13) turned on and with the LED showing
the frequency. After 5 seconds, the LED will change back to show the time.
2. Press the BAND button (3) once repeatedly to choose the radio band.
Consequently, the AM indicator (10) or the FM indicator (13) will be turned on
to show the chosen radio band.
3. Adjust the volume by pressing VOL+ button (2) to increase or pressing
VOL- button (1) to decrease.
Note: Volume range: 00 (mute) to 16 (maximum)
4. Press TUN- button (8) or TUN+ button (7) to tune into the desired station by
either of the 2 following methods :
Manual Tuning : Press either of the 2 tuning button, TU- button (8) or TU+ (7),
repeatedly until the desired station is reach.
For AM tuning, the radio can tune starting from 522 KHz to 1620 KHz, each
pressing of TU- button (8) can tune down by 9 KHz and each pressing of
TU+ button (7) can tune up by 9KHz.
For FM tuning, the radio can tune starting from 87.5 MHz to 108 MHz, each
pressing of TU- button (8) can tune down by 0.1 MHz and each pressing of TU+
button (7) can tune up by 0.1 MHz.
Auto Scanning: Press and hold either of the 2 tuning button, TU- button (8) or
TU+ (7) for more than 1 second and auto scan will be performed. Scanning will
stop automatically until a clear radio signal is found. Repeat the same
procedure by using the same button until your desired station is found.
* To stop auto scanning, press any button once.
Note : In some area where the radio signal is not strong enough, the scanning
process may not be able to stop automatically in the desired station. In such
case, please use the Manual Tuning method to tune the desired station. This
happens more probably when tuning the radio in AM band.
5. To turn off the radio, press and hold ON/OFF button (3) for more than 1 second