Table of Contents
Advertisement
1. When the radio is on (either AM or FM), press SET button (4) or MEMORY+ (6)
once, then the radio will be tuned to station stored in the preset number next to
the last loaded preset number.
Press MEMORY- button (5) once, the radio will be tuned to station stored in the
preset number previous to the last loaded preset number.
2. You can choose your desired preset memory by pressing MEMORY- button (5) to
step down the sequence or MEMORY+ button (6) to step up the sequence.
3. After the preset number is chosen, it will be shown for 2 seconds, then the LED
will change back to show the radio frequency.
Important Note: Please do NOT hold (press continuously) the SET button (4) in this
stage. If this is done by mistake, the unit will enter into the mode of presetting
the station, with the preset number flashing. In such case, do not press any
button until the LED stop flashing. Otherwise, your set memory may easily be
disturbed by your wrong operation procedure.
TIME SETTING
1. When the unit is first plugged into the AC mains, "0:00" will appear and flash on
the display.
2. Press HOUR button (8) for hour setting.
3. Press MINUTE button (7) for minute setting.
4. After setting to the correct time, either press SET button (4) once, or just leave 5
seconds, then the display stop flashing, and the clock will start run from the set
time.
5. To adjust the current time, first switch off the radio. Press and hold SET button
(4) for 1 second until the display flashes, then follow the same steps as point 2, 3
& 4 above to set the new time.
DUAL ALARM FUNCTION
This product allows the user to set to dual alarm function. Each alarm function can
be set independently, either wake to radio, or wake to buzzer. When any one alarm
is set waking to radio, please remember to select the desired band, station and
volume level before turning off the radio
ALARM SETTING
Advertisement
Table of Contents
