DJH MEK RUB TEST MACHINE User Manual page 6

MACHINE INSTALLATION
Select a suitable area for the machine. The machine weight is 62.5 lbs. (30 kg) and must be installed on a sturdy
work bench that will be able to absorb the inertia of the dead weight rubbing block being shuttled back and forth.
It is recommended that the work area have at least 30cm clearance on all sides.
The machine comes with two (2) mounting plates to secure the machine to the tabletop. Please refer to the diagram
below for recommended method of installation. Place the anti-skate pads under the corners of the machine as
shown. For metal bench tops mark the screw locations drill pilot holes and then screw the brackets onto the
worktable surface. For wood benches and surfaces simply attach using #10 wood screws.
Anti-Skid Pad
WARNING
Failure to secure the machine to the work table may result in the machine falling off the table, serious damage
to the machine and or personal injury can occur due to the weight of the machine.
6