Safety Precautions - mabe PVUS930 Service Manual

Before connecting the model to the electricity
network:
- Check the data plate (positioned inside the
appliance) to ascertain that the voltage and power
correspond to the supply circuit. If in doubt ask a
qualifi ed electrician.
- If the power supply cable is damaged, it must be
replaced with another cable or a special assembly,
which may be obtained direct from the manufacturer.
- This device must be connected to the supply
circuit through a hardwired spur protected by 3A
fuse.
WARNING !
In certain circumstances electrical appliances
may be a danger hazard.
A) Do not check the status of the filters while
the cooker hood is operating
B) Do not touch bulbs or adjacent areas, during
or straight after prolonged use of the lighting
installation
C) Flambè (Flamed) cooking is prohibited
underneath the cooker hood
D) Avoid free flame, as it is damaging for the
filters and a fire hazard
E) Constantly check food frying to avoid that
the overheated oil may become a fire hazard
F) Disconnect the electrical plug prior to any
maintenance
G) This appliance is not intended for use by
young children or infirm persons without
supervision
H) Young children should be supervised to
ensure they do not play with the appliance
I) There shall be adequate ventilation of the
room when the rangehood is used at the same
time as appliances burning gas or other fuels
L) There is a risk of fire if cleaning is not carried
out in accordance with the instructions
M) Please use a dedicated plug receptacle for
power plug
N) Please don't operate the hood when there is
a flame on the dishes or frying pan
O) Please don't touch the product or operate
the switch with wet hands
P) Please don't wipe off the hood with the
chemicals when cleaning.

Safety precautions

The symbol on the product or on the accom-
panying paperwork indicates that the appliance
should not be treated as domestic waste, but
should be delivered to a suitable electric and
electronic appliance recycling collection point.
Follow local guidelines when disposing of waste.
For more information on the treatment, re-use and
recycling of this product, please contact your local
authority, domestic waste collection service or the
shop where the appliance was purchased.
Assembly and electrical connections must be
carried out by specialised personnel.
• Electric Connection
The connection to the mains is carried out as
follows:
BLACK = L line
WHITE = N neutral
GREEN/YELLOW = G ground
Connect to a junction box suitable for the electrical
load indicated on the description label.
An omnipolar switch with a minimum opening of
3mm between contacts, in line with the electrical
load and local standards, must be placed between
the appliance and the network in the case of direct
connection to the electrical network.
Before proceeding with the assembly operations,
remove the anti-grease filter(s) so that the unit is
easier to handle.
In the case of assembly of the appliance in the
venting version prepare the hole for evacuation of
the air.
• We recommend the use of an air exhaust tube
which has the same diameter as the air exhaust
outlet hole. If a pipe with a smaller diameter is
used, the efficiency of the product may be reduced
and its operation may become noisier.
- 4 -