mabe PVUS930 Service Manual page 14

Phase 1
Phase 2
Phase 1
- Before carrying out assembly operations, open the packaging,
take the hood and place it on a comfortable surface.
- Remove the anti-grease filter/s as shown in the picture.
Phase 2
- If hood installation is used with the air outlet Fig.1B or
Fig.4B, the wires set-up in the relevant wiring harness must
be released by pulling the lever outwards, as indicated in
figure 2, phase 1-2.
- Disconnect the 6-way quick coupling of the motor located
inside of the hood, as show in figure 2. - phase 3.
- The wires positioned inside of the hood are fasted with a
cable tie. Cut the cable tie as shown in figure 2 - phase 4.
fig.1B
fig.2
fig.4B
Once transformation operations have been completed,
reassemble the components following
the steps in reverse (Fig.2).
In this way it will be easier to manoeuvre the unit.
- If the appliance is to be mounted in DUCTING version,
prepare the air evacuation hole.
- It is recommended to use an air evacuation pipe with the
same diameter as the air outlet
flange. The use of a reduction could decrease product
performance and increase noise.
- 14 -
Installation