Siemens 5WG1 258-2EB22 Technical Product Information page 8

Installation in UP socket using screws
The device is secured with fixing screws in the UP socket. The
device can be installed offset by 90° with the additional fixing
holes.
Note:
·
Fixing clamps must not be mounted!
E1 Device
E2 Socket fixing screws
E3 UP socket Depth: min. 40mm, Æ 60mm
Mounting the fixing clamps for mounting the device in suspend-
ed ceilings
Extend the fixing claws slightly and push over the lugs on the
device.
Installation in suspended ceilings with fixing clamps
Press the fixing clamps together (see figure 7) and
push the device into the opening (Æ 60mm - 65 mm)
with the fixing clamps in front.
The fixing clamps hold the device on the ceiling.
Max. thickness of the suspended ceiling: 30mm
Caution:
· When dismounting the device hold it where the two housing parts are joined together.
Otherwise, the fixing clamps may hit your fingers.
Cutting the shade
If the detection range of the motion sensor must be reduced, a
shade can be used.
The shade is cut out in the wanted sectors with a knife.
Caution:
●
●
8 / 12
Update: http://www.siemens.com/gamma-td
January 2015
F1
F2
F3
F1 Suspended ceiling
(max. thickness of the suspended ceiling: 30mm)
F2 Fixing clamps
F3 Device
Do not cut out the mounted shade!
Only cut out the dismounted shade!
UP 258E22, UP 258D12, UP 255D21
G1 Device
G2 Fixing clamp
ã Siemens AG 2015
Subject to change
Siemens AG
Building Technologies Division
Control Products and Systems
P.O. Box 10 09 53, D-93009 Regensburg
E3
E1
E2