AEG 88001 K-IN User Manual page 26

26
Installation Instructions
Avoid installing the appliance next to doors and under windows. Otherwise hot
cookware may be knocked off the rings when doors and windows are opened.
z
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti shock protection by installing correctly.
• The appliance must be connected to the electrical supply by a qualified elec
trician.
z
Risk of injury from electrical current.
• Loose and inappropriate plug and socket connections can make the terminal
overheat.
• Have the clamping connections correctly installed by a qualified electrician.
• Use strain relief clamp on cable.
• In the event of single phase or two phase connection, the appropriate mains
cable of type H05BB F Tmax 90°C(or higher) must be used.
• If this appliance's mains cable is damaged, it must be replaced by a special ca
ble (type H05BB F Tmax 90°C; or higher). The latter is available from the Cus
tomer Care Department.
A device must be provided in the electrical installation which allows the appli
ance to be disconnected from the mains at all poles with a contact opening
width of at least 3 mm.
Suitable isolation devices include line protecting cut outs, fuses (screw type fus
es are to be removed from the holder), earth leakage trips and contactors.
Sticking the seal in the rabbet
• Clean the rabbet in the work surface.
• Stick the one sided self adhesive sealing tape supplied onto the upper surface
of the rabbet along the edges of the cut out section.
– Cut the sealing tape into four pieces relating to the length of the edges of
the rabbet.
– For the four corners of the rabbet the ends of the sealing tapes must be cut
into mitres. Do not stick the ends over one another.
– Stick the sealing tape flush into the corner of the rabbet, so that no silicon
compound can get under the glass ceramic when grouting.
– Don't stretch the tapes when sticking them on.