AEG SANTO 70290-8 DT Operating Instructions Manual page 42

- Remove with a tool the cover (e)
unscrew the lower hinge pivot (f)
and rescrew on the opposite side
- Refit the cover (e) on the opposite
side.
- Insert the middle hinge pivot into
hole on the left of the refrigerator
door.
- Insert the refrigerator door on the
lower hinge pivot (f) .
- Insert the freezer door on the upper
hinge pivot and tilt slightly the doors
and insert the middle hinge pivot
into the hole on the left side of the
freezer door.
- Opening the doors, fix the middle
hinge on the left side with two
screws. Do not forget the plastic
spacer that must be placed under the
middle hinge (H).
- Dismantle the handles, by sliding
the handle-cover, by unscrewing
1
its side and middle screws and
2
reassemble them on the opposite
side. Cover the holes left open
with the plugs contained in the
documentation pack.
Pay attention that the border of the doors are parallel to the top border.
Reposition, level the appliance and connect it to the mains socket.
In any case you do not want to carry out the above mentioned operations,
contact the nearest After Sales Service Force.. The After Sales Service
specialist will carry out the reversibility of the doors at your cost.
Attention:
After having reversed the opening direction of the doors check that all the
screws are properly tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. in that case, wait for the natural fitting of
the gasket or accelerate this process by heating up the part involved with a
normal hairdrier.
42