Electrolux SHM 305 Instruction Book page 5

Insert/release attachment
0
1. Press the whisk or dough hooks
into the attachment holder (7) at the
bottom of the hand mixer until you
feel it/them click in.
1
The two dough hooks have different
insertion shapes. They have to be
inserted into the correct attachment
holder (7) as if this is not done, the
dough is transported upwards!
0
2. Switch the hand mixer off after use.
3. Pull out the mains plug.
4. Press the ejector button (2) and
remove the attachments.
Quick mix rod:
0
1. Push the slide (10a) backwards.
2. Insert the quick mix rod into the
attachment holder (10b), so that the
markings on the quick mix rod and
housing are opposite each other.
3. Tighten the quick mix rod by turning
it clockwise (10c). The quick mix rod
can only be operated in the instant
setting.
4. If the slide is pulled back as far as it
will go, the hand mixer can be rested
on it during a rest.
5. After use unscrew the quick mix rod
by turning it anti-clockwise.
6. Remove the quick mix rod.
Mini chopper:
1
Risk of injury: the chopping blade
(11a) is very sharp. Only hold it by
the plastic part.
0
1. Attach the chopping blade (11a) onto
the axle of the mini chopper.
2. Attach the non-slip rubber ring on
the exterior of the bottom of the mini
chopper.
3. Fill the food to be processed into the
mini chopper.
4. Attach the drive unit onto the mini
chopper (11b), so that the markings
on the drive unit and the mini chop-
per are opposite each other.
5. Place the hand mixer onto the mini
chopper (11c).
6. Mini chopper can only be operated in
the moment level.
7. After you have finished, switch off
the hand mixer and pull out the
mains plug.
1
Wait until the chopping blade comes
to a standstill before you remove the
hand mixer from the mini chopper.
0
8. Remove hand mixer from the mini
chopper.
9. Push the locking button to the back
(11d) and remove the drive unit from
the mini chopper.
Automatic lead winder
0
1. Pull the lead out of the hand mixer. It
will catch at any length desired (max.
1.45 m).
2. After using the hand mixer slightly
tug the lead. This releases the lead
again and it ist wound up by the
automatic lead winder. Guide the
lead with your hand whilst it ist being
wound up.
1
On no account should you push the
lead into the hand mixer manually as
the automatic lead winder could get
damaged.
Switch on the hand mixer
1
Never switch the hand mixer on
when no attachments have been
inserted.
Using the on/off switch (1)
– you can switch the appliance on and
off,
– you can infinitely adjust the motor
speed,
– you can choose the instant setting
"M". In the instant setting "M" the
hand mixer works as long as you
push the on/off switch to the left. The
appliance runs at top speed for as
long as the switch is activated.
5