MSI MS-7380 Getting Started page 17

Fan Power Connectors: CPUFAN1, SYSFAN1
The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to GND.
If the mainboard has a System Hardware Monitor chipset on-board, you must use a
specially designed fan with speed sensor to take advantage of the CPU fan control.
Important
1. Please refer to the recommended CPU fans at processor's official website
or consult the vendors for proper CPU cooling fan.
2. Fan/heatsink with 3 or 4 pins are both available for CPUFAN1.
SPDIF-Out Connector: JSPDIF
This connector is used to connect S/PDIF (Sony & Philips Digital Interconnect Format)
interface for digital audio transmission.
CONTROL
SENSOR
+12V
+12V
GND
GND
CPUFAN1
JSPDIF
VCC
SPDIF
GND
Hardware Setup
NC
SYSFAN1
2-13