Fujitsu ASYA09KLWA Design & Technical Manual page 21

• UP Button (
Increase or decrease set temperature.
NOTE: Temperature control is not available in Fan mode.
• SLEEP:
Select this function during the sleeping time. It keeps the most comfortable temperature and
save energy. This function is available in COOL, HEAT or AUTO mode only.
NOTE: While the unit is running in sleep mode, it would be cancelled if MODE, FAN
SPEED or ON/OFF button is pressed.
• TURBO:
Turbo function enables the unit to reach the preset temperature at cooling or heating operation
in the shortest time (if the indoor unit does not support this function, there is no corresponding
operation happened when pressing this button.)
• SILENCE:
When the Silence function is activated, the compressor will operate at low frequency and the
indoor unit will bring faint breeze, which will reduce the noise to the lowest level and create a
quiet and comfortable room for you. Due to low frequency operation of compressor, it may re-
sult in insufficient cooling and heating capacity.
• FP (8 °C heating):
Push FP button for 2 seconds to activate 8 °C heating function. This fuction can only be acti-
vated in heating mode. The unit will operate at a setting temperature of 8 °C. Indoor buzzer
will beep 0.7 and 0.3 seconds respectively for entering or exiting 8°C heating mode. Press the
buttons of ON/OFF, SLEEP, FP, MODE, FAN SPEED, UP or DOWN while operating will can-
cel the FP function.
• TIMER
TIMER ON: For time on setting. Once pressing this button, the time will increase by 0.5 hour.
When the set time exceeds 10 hours, pressing the button will increase the time by 1 hour. Ad-
just the figure to 0.00 will cancel time ON setting.
TIMER OFF: For time off setting. Once pressing this button, the time will increase by 0.5 hour.
When the set time exceeds 10 hours, pressing the button will increase the time by 1 hour. Ad-
just the figure to 0.00 will cancel time OFF setting.
• SWING:
Stop or start horizontal louver auto swing feature.
• DIRECT:
Change the louver movement and set the desired up/down air flow direction. The louver
changes 6° in angle for each press.
• LED:
Disable/active indoor led light.
• CLEAN:
Airborne bacteria can grow in the moisture that condenses around heat exchanger in the unit.
By pressing the CLEAN button, indoor unit will clean itself automatically. After cleaning, air
conditioner will turn off automatically.
NOTE: CLEAN function can be only activated in COOL or DRY mode.
• FOLLOW:
FOLLOW ME function enables the air conditioner to collect room temperature from the loca-
tion of remote controller, which reflects the actual temperature around you and ensures maxi-
mum comfort.
8-1. Wireless remote controller
) and DOWN Button ( )
- 17 -
8. Remote controller