Changing The Telescope Adapter - Moravian Instruments G2 Series Mark II User Manual

Changing the Telescope Adapter

All adapters of the Mark II cameras are attached using three "pulling"
screws. As the adapter tilt is adjustable, another three "pushing" screws
are intended to fix the adapter in place.
If the adapter has to be replaced for another one, it is necessary to
unscrew the three pulling screws. The adapter then can be removed and
replaced with another one.
Warning:
Both pulling and pushing screws, used on the G2 camera adapter, are
fine-pitch M4×0.5 thread screws, not standard M4 thread ones. Always
use only screws supplied with the adapter, using of normal M4 screws
damages the adapter.
Always make sure to carefully locate the ring-shaped spring prior to
attaching the adapter.
Figure 27: Removing of the adjustable telescope adapter
41