Power Supply - Moravian Instruments G2 Series Mark II User Manual

CCD chip cooling
Maximal cooling ΔT
Regulated cooling ΔT
Regulation precision
Hot side cooling
Maximum temperature difference between CCD and ambient air may
be reached when the cooling runs at 100% power. However,
temperature cannot be regulated in such case, camera has no room
for lowering the CCD temperature when the ambient temperature
rises. Typical temperature drop can be achieved with cooling running
at approx. 85% power, which provides enough room for regulation.

Power supply

The 12 V DC power supply enables camera operation from arbitrary power
source including batteries, wall adapters etc. Universal 100-240 V AC/50-
60 Hz, 60 W "brick" adapter is supplied with the camera. Although the
camera power consumption does not exceed 55 W, the 60 W power supply
ensures noise-free operation.
Warning:
The power connector on the camera head uses center-plus pin.
Although all modern power supplies use this configuration, always
make sure the polarity is correct if you use own power source.
Camera head supply
Camera head power consumption
Power connector
Adapter input voltage
Adapter output voltage
Adapter maximum power
22
Thermoelectric (Peltier modules)
>50 °C below ambient
48 °C below ambient (85% cooling)
±0.1 °C
Forced air cooling (fan)
12 V DC
15 W without cooling
40 W maximum cooling
5.5/2.5 mm, center +
100-240 V AC/50-60 Hz
12 V DC/5 A
60 W