Installing The Handset Battery - GE InfoLink 28320 User Manual

Installation
8
Your unit is provided with three power adaptors;
2 for handset charger cradles and 1 base power.
The connectors are different sizes, only the larger
connector/adaptor fits the base/gateway unit

Installing the Handset Battery

1. Locate batteries and battery door which are
packaged together inside a plastic bag and are
separate from the handsets.
2. Locate the battery compartment on the back of the
handsets.
3. Insert the batteries.
4. Close the battery compartment by pushing the door
up until it snaps into place.
5. Plug the AC power adaptor of the charge cradle into
an electrical outlet.
4. Place the handsets in the charge cradles. The blue
CHARGE indicator turns on, verifying the batteries
are charging.
Allow handset to charge for
use. If you do not properly charge the handset,
battery performance is compromised.
1 hours prior to first
CAUTION: To reduce the
risk of fire or personal
injury, use only the
Thomson Inc. approved
model GP AAAHC 1.2V
0mAh, rechargeable
Nickel-metal Hydride
AAA batteries, which are
compatible with this unit.
Battery performance
When batteries are fully
charged the handset display
shows green bars. To keep
your batteries in the best
condition, leave the handset
off the chagre cradle for a
few hours at a time (after the
initial 16 hour charge).
Please note however, that
new NiMH batteries do not
reach full capacity until they
have been in normal use for
several days.
Battery Low Warning
The handset battery symbol
is empty and flashing and
you will hear a warning beep.
Start recharging your handset
right away.
When charging the battery,
level bars are animated.
Battery Charging Light
The blue charging light on
the handset charge cradle
stays on while the handset is
on the cradle, even when the
batteries are fully charged.