Nortel 6220 User Manual page 63

64
Figure 4-5
Configurator Starting Window
7. In case you want to forcibly setup IP address, follow this procedure
as below.
8. Right click on the IP address of CSU, and then select 'Configure This
Device'. or click "Configure Remote" button below the list box.
9. The Change IP window is displayed, as shown in the following
screenshot.
Figure 4-6
IP setup dialog box
10. Enter an IP address that will be local to the IP of the PC/laptop
running the Configurator, and then click the OK button in Read Write
Password window.
Note: The IP address to enter should be included in the same subnet area
with PC/Laptop computer for access to CSU.
For example, in case the IP address of Laptop computer is
192.168.0.100/24, the CSU will be allowable in 192.168.0.1/24 ~
192.168.0.254/24 as the IP address subnet group.
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005