Turning The Archos On/Off - Archos TV+ User Manual

TV+
* North America: If either your tuner or TV does not have S-video connections,
use a standard RCA video cable (- - - - ) instead of the S-video cable. In this
case, set the TV Connection to "Composite". See "TV Settings".
Connect the included charger/adapter to the jack labeled DC-IN on the back of
1.
the ARCHOS.
2. Then plug the other end of the charger/adapter into an available wall socket.
If you have correctly connected the charger/adapter, the red LED indicator (on
the front of the device, on the left side) will start blinking while the device is
booting. When the ARCHOS is on, the green LED will light up.
Use only the supplied ARCHOS charger/adapter as other adapters may dam-
age this device (even if they give the same voltage rating).
3. Connect the ARCHOS' outputs to your TV's inputs. See the Connection Diagrams
for Europe and North Armerica (previous page).
4. Make sure that your TV is switched to the AV input that is used to connect the
ARCHOS.
5. When the image of the ARCHOS appears on your TV, follow the instructions on
screen (installation wizard) to finish installing the ARCHOS.
Make sure that you set the ARCHOS "TV Settings" based on how you have
connected the ARCHOS to your TV. See "TV Settings".

TURNING THE ARCHOS ON/OFF

• Press and hold the
it into standby mode.
• The green LED indicator, on the front of the device, lights up when the device is
on. The red LED indicator lights up when the device is in standby mode.
V0.9
MANUAL
button, on the remote control, to turn on your ARCHOS or put
INTRODUCTION > P. 8