Sleep Timer Setting; Configuration - Ocean Digital WR-10 User Manual

Alarm Volume - Adjust the volume of the alarm as you like by rotating the [Tune/Select]
After the above settings are completed, press the [ ◄ ] button to exit and make sure the Alarm
is turned on. You will see the Alarm icon appeared on the display if it is activated.

10. Sleep Timer Setting

You can set the timer to let the radio goes standby after the selected time elapsed in the range
of 15 minutes to 180 minutes.
Press [ ] button on the remote control to set the timer.
You will see the icon appeared on the display if the timer is set.
11. Configuration
Here you will find the complete settings / options available to configure your own tuner. On the
main menu, navigate to Configuration setting. Press OK and you will see a list of options
available.
Wi-Fi Network
• Add / Remove AP
Add AP - It will scan out a list of routers around.
Remove AP - If you have already added a router and want to remove it, choose this
option.
Note - Always bring the Tuner within 2 meters of the Wi-Fi router for setup.
• AP: [ ]
If you have added more than one routers on the radio and want to switch to another one,
select this option to change.
• Signal
This is to show the strength of the Wi-Fi Signal of the Wi-Fi router as received by the
radio. Usually signal levels lower than -70dBm is at weaker level and if it affects the
reception of your radio, you may need to optimize the router location or check any
problem of the router itself.
• IP
The IP is set Dynamic by default. Select to change Fixed IP according to your network
condition.
• DNS
The DNS is set Dynamic by default. Select to change <Fixed> DNS according to your
network condition.
knob or [▲/▼] button on remote.
- 12 -