Bluetooth Playback; Alarm Setting - Ocean Digital WR-10 User Manual

Manual Tune
To manual tune to the frequency, long press the [OK] on remote or long press [Tune/Select]
on the unit, until you see the "Tuning" appeared on the display, at the bottom right corner.
Use the < ◄ /► > button on remote to tune the frequency. When done, long press the [OK]
button to exit manual tune.

8. Bluetooth playback

Before transmission between your Bluetooth device and the radio is possible, both devices
must be coupled. This process is called "pairing". The Tuner is served as a receiver, to receive
music stream to play on the Tuner.
If you have already coupled to a Bluetooth device before, this connection will be restored
automatically when both devices are in range and Bluetooth operation has been selected on
the radio. "Pairing" does not have to be repeated. This function may need to be activated in
your Bluetooth device, however.
• Push the Menu button to display the selection menu for the different operating modes.
• Use the up / down button to select the operating mode Bluetooth and push the dial switch.
• Switch your Bluetooth device to which you want to connect the radio on and activate the
pairing mode here. The device scans for Bluetooth devices in the reception range.
• When the radio is found, your bluetooth device shows its name WR-10-XXXX (the XXXX is an
identification code for your radio unit).
• Select the radio at your bluetooth device.
• Start playback on your bluetooth device.
• Playback now takes place using the radio.

9. Alarm Setting

• Choose Alarm from the main menu or press the [Alarm] button on the remote control.
• Select either Alarm 1 or Alarm 2, choose Turn on to activate the Alarm.
• Follow the alarm wizard instructions to set the alarm.
• The wizard will guide you through the settings below:
Time - Set the time for the alarm
Sound - You can choose Wake to Tone, My Favourite, Wake to FM Radio or Wake to
DAB Radio as the alarm source.
Note - Wake to FM or Wake to DAB Radio - only the preset stations can be used
for the radio alarm (if the preset scan has been completed).
Wake to My Favourite - Please preset your favorite station before setting this as
Repeat - You can schedule the alarm as you desire-Everyday, Once or multiple days.
the alarm source.
- 11 -